Short answer: this is a rough rule of thumb, not a Manual J load calculation. The traditional rule is about 1 ton of cooling per 500 square feet. Florida Solar Energy Center (FSEC) researchers say 700 to 1,000 square feet per ton fits most well-built homes. For a 2,500 square foot Katy home, those two rules give about 2.5 to 5 tons, which is exactly why only a room-by-room Manual J calculation should set the size.
AC size checker
Use the area served by the system you are checking. Two-story homes often have one system per floor.
How the checker works
Square feet divided by square feet per ton gives tons. The checker uses two published ranges and rounds to the nearest half ton.
| Rule | Square feet per ton | Source |
|---|---|---|
| Traditional rule of thumb | 400 to 600 (500 typical) | Florida Solar Energy Center (FSEC) contractor survey: weighted average 502, range 350 to 700; ACCA's HVAC blog: contractors "usually pick a number between 400 and 600" |
| Well-built homes | 700 to 1,000 | Florida Solar Energy Center (FSEC): modify the square foot method "to 1 t per 700 to 1000 ft2 for most well-designed and quality-built homes," for estimating only |
| Typical new Texas home studied (measured) | 588 | South-central Partnership for Energy Efficiency as a Resource (SPEER) Texas Energy Code Field Study of new homes, which found the typical Texas home studied had an oversized AC |
| 40 Manual J calculations, hot and mixed climates | 624 to 3,325 (average 1,431) | ACCA's HVAC blog |
Methodology and limits
- Home age. Homes built before 2010 get the traditional 400 to 600 range; homes built in 2010 or later get the 700 to 1,000 range. The 2010 cutoff is this tool's own simplification for newer, tighter construction. It is not a building code date. Pick "Not sure" to see both.
- Why it is only a rough range. U.S. Department of Energy guidance warns against "casual sizing estimates based on home floor area" and points to ACCA Manual J and Manual S. ACCA's HVAC blog puts it plainly: "you can't use square feet per ton to size air conditioners."
- Why it still helps. If your current system is well above both ranges, that is a reason to ask any installer whether a Manual J calculation was done. SPEER says ACCA-sized systems "should usually have at least 800-900 square feet per ton."
- Privacy. Nothing you type is sent anywhere. The math runs in your browser.
Sizing in Katy's climate
Katy summers are long and humid. At the nearest long-record NOAA station, there were about 130 days a year at 90°F or hotter from 2016 to 2025 (see Katy heat data). Humidity is the reason oversizing matters here: a system that cools the air quickly and shuts off may not run long enough to dry it. See Houston humidity and AC problems.
More homeowner tools: repair or replace calculator, refrigerant and age checker, or see all tools.
Frequently asked questions
How many square feet does a ton of AC cool?
There is no single answer. The traditional rule of thumb is about 500 square feet per ton. FSEC researchers say 700 to 1,000 square feet per ton fits most well-built homes, and 40 Manual J calculations reviewed on ACCA's blog ranged from 624 to 3,325 square feet per ton.
What is a Manual J load calculation?
Manual J is the Air Conditioning Contractors of America procedure for a home's heating and cooling load. It accounts for wall, ceiling, window and floor area, insulation, air leakage, orientation and more. Manual S then picks equipment to match.
Is a bigger AC better in Katy humidity?
No. The U.S. Department of Energy says oversized systems short-cycle, which can lead to poor humidity control in humid climates, and the extra starts add wear.
Can this tool tell me what size AC to buy?
No. It gives a rough range from rules of thumb. Only a Manual J load calculation for your home should set the size.
Talk to a local AC pro
Replacing a system and want the size checked with a load calculation? Call (281) 653-5399 to get connected with an independent local HVAC company that serves Katy, Cinco Ranch, Fulshear, Richmond and nearby. The pro inspects the system and gives their own estimate before any work.
Next steps: AC repair in Katy, AC installation and replacement, maintenance and tune-ups and emergency AC repair. Neighborhood pages: Cinco Ranch, Cross Creek Ranch and Fulshear.